|
Quick Tech Tips: 1— If you are going to use the AMS-1000 in time
based or shift input mode(not GPS) you will need to supply switched 12 volts
to terminal number 1. This input will need to be turned on and off. Think of
it like this, when the switch is off(not supplying 12 volts to terminal
number 1) the AMS-1000 is in PROGRAM mode, allowing you to make changes to
the program. When the switch is on(12 volts being applied to terminal number
1) the controller is in RUN mode and will not let you make changes as it is
trying to run its program. This is an activation input , you will still nee
to supply power to terminal 8 and a ground to 9. PLEASE SEE INSTRUCTIONS FOR
MORE INFORMATION! 2 — Make sure you configure the input polarity for
the (shift, clutch, scramble, reduce) before you connect your wires. If you
have it configured for the wrong polarity the input will go on and stay on.
If this has happened removed the wire and go in and change the input polarity
and reconnect the wire. PLEASE SEE INSTRUCTIONS FOR MORE INFORMATION! 3 — Clutch input can be used as a transbrake input. 4 — Mounting the pressure sensor in the gate will
have the best results. Drill and tap for a 1/8 npt and screw in sensor. Mount
solenoids as close to gate as possible. If you cannot mount sensor in the
gate then tee it in as close as possible. 5 — Co2 as pressure source is recommended as it has
many benefits. Run as small as a spring as you can and let the controller do
the rest! |